Tesla Model S Jack Pad Adapter Lift Pad Tire Service 2012-2020

Tesla Model S Jack Pad Adapter Lift Pad Tire Service 2012-2020

Tesla Model S
item image

Price: 29.95 USD

Tesla Part Info:

Tesla Model S Jack Pad Adapter Lift Pad Tire Service 2012-2020

FITS 2012-2020 ONLY

This is for “1” ONE, UNO, SINGLE JACK PAD

Why Murphy’s Law Jack Pads?

Our products are designed in the field and worked every day not just another part to add to a list.

Murphy’s Law Jack Pads are specialty tools sold by a company that actually uses them.

We only make Tesla products.

Our tool will give you the confidence in lifting your Tesla without damage.



**Must be used with a low profile floor jack with a wide ROUND FLAT saddle plate no smaller than 3.75″ in diameter, see pictures for reference.”. **

 This will only fit a Model S

Should only be used on a flat level surface free from rocks or gravel. Click here to watch how to properly lift and change your tire on a Tesla Model S, Model X or Model 3.  Floor jacks need this to roll forward under the vehicle when being lifted, failure to lift the vehicle with the wrong floor jack or on a rough rocky surface could result in damage. User Responsible for damage due to faulty or wrong equipment or lifting the vehicle on a poor work surface is solely the purchaser.

This specialty tool was made out of a need to more safely lift and service the Tesla Model S.

Great for just normal maintenance when removing the wheel is needed or swapping your winter tires over to summer set.

This lift plate adapter gives you clearance both in height and keeps your floor jack away from the $35k battery pack on all Tesla Model S.

No hassle or fighting to line up the jack with the plate, easily slide the cylinders into the receiver holes on your lift plate under your vehicle and the magnetic force holds it in place then slide you floor jack under to lift. Just a 1/4″ too far inward can damage that very expensive battery pack and leave you out of pocket.

Works with 2-3 ton low profile floor jacks. Set air suspension on highest setting then jack mode.

********DO NOT USE WITH JACK STANDS*********

Heavy duty 3d printed ABS.

Hand made in Texas we do not sell cheap Chinese junk.

********DO NOT USE WITH JACK STANDS*********

Patent pending

Murphy’s Law Jack Pad Adapters Inc. All rights reserved.

Murphy’s Law Jack Pad Adapters Inc. is an independent company and is not affiliated with Tesla Motors, Inc. or its subsidiaries. TESLA, TESLA MOTORS, TESLA ROADSTER, MODEL S, MODEL X, and the “TESLA,” “T” and “TESLA and T in Crest” designs are trademarks or registered trademarks of Tesla Motors, Inc. in the United States and other countries

International Buyers – Please Note:

Import duties, taxes, and charges are not included in the item price or shipping cost. These charges are the buyer’s responsibility.

Please check with your country’s customs office to determine what these additional costs will be prior to bidding or buying.

Customs fees are normally charged by the shipping company or collected when you pick the item up. These fees are not additional shipping charges.

We won’t under-value merchandise or mark the item as a gift on customs forms. Doing that is against U.S. and international laws

Leave a Reply

Your email address will not be published.