For Tesla 3 Spoiler Wing Glossy Carbon Fiber Spoiler Rear Trunk Lip 2017-2022

For Tesla 3 Spoiler Wing Glossy Carbon Fiber Spoiler Rear Trunk Lip 2017-2022

Tesla Model 3
item image

Price: 53.09 USD

Tesla Part Info:

For Tesla 3 Spoiler Wing Glossy Carbon Fiber Spoiler Rear Trunk Lip 2017-2022



eBay

spoiler has a sleek profile  1  

Features:
Fitment: Rear Trunk Lip Spoiler Fits Tesla Model 3 2017 2018 2019 2020 2021
High Quality: This Rear Trunk Spoiler Wing is made of lightweight & top-grade durable ABS Plastic material. Each product is protected with UV-resistant glossy clear coating to prevent from color fade.
Features: Glossy Carbon Fiber, with gloss look and stylish design, the new spoiler works fine and enhances overall performance in handling and durability.
Improve Stability: This rear spoiler wing helps to add more downforce and helps aerodynamic of your Tesla Model 3,the rear wing can maintain the stability of the vehicle when at high speeds, reducing wind resistance, saving fuel and keeping safety, make the driver feel more comfortable.
Easy Install: The spoiler is for a simple do-it-yourself installation. Ttape on the back for an easy peel and stick installation.
 
 
Specification:
Warranty: 3 Year Warranty
Quantity: 1 piece
Fitment:  Fit for Tesla Model 3 2017 2018 2019 2020 2021
Item Weight: 2.65 pounds
Package Dimensions: 49 x 10.8 x 2 inch
 
 

Package Included:

1*Fit for Tesla Model 3 Trunk Spoiler

 

Tesla model 3 rear wing installation steps: (Important, please follow the steps, your installation steps are very important) (also cry reference video)
1. Wipe the installation position with a towel to clean up the dust in the installation position
⁣2. Compare the installation position, and probably test the two sides to be symmetrical to each other
⁣3. Wipe the installation position with adhesion promoter
⁣4. Tear off a piece of tape at both ends, ready to install
⁣5. First fit the middle position of the rear wing to the vehicle and press hard
⁣6. Install both ends again, press and fit on the two sides
⁣7. While pressing and fitting, tear off the adhesive paper and gently tear it apart
⁣8. Carefully tear off the adhesive tape at the lower end of the tail wing
⁣9. Continue to press the rear wing hard, so that the rear wing is close to the vehicle, there is no gap
⁣10. Installation is complete

Installation tips: (important)
The following are two tips when installing, which will keep it in a better state.
1. When the temperature is lower than 10℃, the adhesion becomes weak ℃ (50℉), it will be better to use a hair dryer to heat the double-sided tape. After installation, the tape will not work at low temperatures.
2. Please do not touch water within 48 hours after pasting.

PushAuction



Leave a Reply

Your email address will not be published.